![]() # nmcli networking offĬheck the static IP address configured properly inside the network card. Restart the network service and make the changes effect. Please replace with the correct device name if necessary.Ĭhange the value of BOOTPROTO to static from dhcp and then add the following entries in the network card to configure the static IP address.Įxample for 203.86.232.249: BOOTPROTO=static NOTE: ens3 is the device name of the server. # vi /etc/sysconfig/network-scripts/ifcfg-ens3 # ipconfigĮdit the network configuration file using the below command. To check if the static IP address is configured properly, right-click Start Menu, then click Command Prompt.Įxecute the following command for checking network configuration. Windows Network Diagnostic tool will run to check to see any issues, close this window. Once IP and Subnet are entered, check the box Validate Settings upon exit, click OK and then close the Ethernet property window. Select Use the following IP address: option and configure the static IP address. In the properties window, select Internet Protocol Version 4 (TCP/IPv4) and click Properties button. Right-click adapter with the name Ethernet and select Properties. The same steps can also be used to update the new IP address in the server manually.Ĭlick Start Menu, then click Control Panel option.Ĭlick Change adapter settings in the left panel. This guide outlines the basic steps on how to configure the IP address of your server manually in your Linux or Windows Cloud Servers. DHCP configuration detects IP address setting automatically, whereas static IP configuration requires the IP address settings to be manually set in the server. The IP can be set as either DHCP (automatic) configuration or static IP configuration. Every Cloud Servers will include a public IP address through which the server can be accessed remotely. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |